[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: VSS output

"Shawn R. Lin" wrote:
> 
> What type of signal is the VSS output from the ECM?

I assume you are talking about the 2000 & 4000 ppm outputs from
something like the 1227730?  Those are driven by open collector outputs.
 In other words, switches to ground.  The destination circuit is
expected to have a pullup resistor.

The 4000 ppm output(s) will have the same duty cycle as the VSS sender
signal.  The 2000 ppm outputs will of course be 50% (unless the VSS
input frequency isn't constant.)

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/