[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

IAC Orifice

To: GMECM_DIY_EFI <gmecm@efi332.eng.ohio-state.edu>
Subject: IAC Orifice
From: mswayze@truswood.com (Mike Swayze)
Date: Mon, 10 Jan 2000 09:22:38 -0500
Reply-to: gmecm@efi332.eng.ohio-state.edu
Sender: owner-gmecm@esl.eng.ohio-state.edu

thanks for the info and links on the DIS
info y'all. I got a chance to peruse the
archives this weekend on IAC. I picked
up a 91 Vette IAC this weekend and
should be able to adapt it to the
caddy/olds TB with a brass bushing with
the orifice for the pintle. I looked all
over the archives but could not find the
orifice size for a 350 TPI IAC. I was
hoping to find the stock size and open
it up if I needed to. Any body know what
size the IAC orifice is in a 350 TPI?
again thanks for the info and links on
the DIS
byE
Mike S.

Follow-Ups:
- IAC Orifice Data
  - From: "SPECTRO COATING CORP." <spectro@ma.ultranet.com>

Prev by Date: Re: Freighting an engine.
Next by Date: Re: 4 Cyl 730
Previous by thread: Re: Emulating... the pros
Next by thread: IAC Orifice Data
Index(es):
- Date
- Thread