[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: LT1 manifold question (sort of NOT ECM related)

To: gmecm@efi332.eng.ohio-state.edu
Subject: RE: LT1 manifold question (sort of NOT ECM related)
From: Rick Lindstedt <rick@mafb.org>
Date: Mon, 10 Jan 2000 16:55:01 -0500
In-reply-to: <2B0D2C61F27AD111B62D00A0C9726A13010605E1@XLV_MAIL>
Reply-to: gmecm@efi332.eng.ohio-state.edu
Sender: owner-gmecm@esl.eng.ohio-state.edu

Marteney, Steven J. wrote:

to find some cheap swap meet LT1 stuff. If the LT1 didn't send water into
the intake, where does it go? Direct to the block? It's been a while since
I've peered at an LT1.

The LT1 has a reverse flow design so it goes thru the heads first then the block..as the standard SBC goes thru the block first then the heads...

Rick

References:
- RE: LT1 manifold question (sort of NOT ECM related)
  - From: "Marteney, Steven J." <smarteney@xlvision.com>

Prev by Date: RE: LT1 manifold question (sort of NOT ECM related)
Next by Date: LT1 manifold adaptation (was question)
Previous by thread: RE: LT1 manifold question (sort of NOT ECM related)
Next by thread: Re: LT1 manifold question (sort of NOT ECM related)
Index(es):
- Date
- Thread