[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Crank Angle Sensors

To: <gmecm@efi332.eng.ohio-state.edu>
Subject: Re: Crank Angle Sensors
From: "Bruce Plecan" <nacelp@bright.net>
Date: Tue, 11 Jan 2000 00:08:55 -0500
References: <20000111041004.37823.qmail@hotmail.com>
Reply-to: gmecm@efi332.eng.ohio-state.edu
Sender: owner-gmecm@esl.eng.ohio-state.edu


| Do any SBC use a timing cover mounted crank angle sensor?
Yes
I  Is the reluctor permanently mounted to the crank shaft?
No
I  What is an approximate year and application so I search for one?
96+ Vortec should get ya there, but I don't know about the actual fit of the
cover to an older block.
grumpy

| Thanks,
| Rich
| ______________________________________________________
| Get Your Private, Free Email at http://www.hotmail.com
|

References:
- Crank Angle Sensors
  - From: "Rich Vandervoort" <richvandervoort@hotmail.com>

Prev by Date: RE: Freighting an engine.
Next by Date: Re: Timing Jump on 165/TPI System
Previous by thread: Crank Angle Sensors
Next by thread: Re: Crank Angle Sensors
Index(es):
- Date
- Thread