[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: ECM Bench kelp needed

To: gmecm@efi332.eng.ohio-state.edu
Subject: Re: ECM Bench kelp needed
From: Matt S Bower <m.s.bower@cummins.com>
Date: Thu, 13 Jan 2000 10:11:42 -0500
References: <002d01bf5dd0$810173c0$400ac9d8@v1b1k1>
Reply-to: gmecm@efi332.eng.ohio-state.edu
Sender: owner-gmecm@esl.eng.ohio-state.edu

Bruce Plecan wrote:
> 
> I have a wiring diagram for my DIS signal generator that uses two 74LS161s.
> I have been every where locally and no one has them.   I have found some
> similiar part nos. at Digi-Key,  those being a:
> DM74S161-ND,   and a
> MM74HC161N-MM
> Can I use these?, one perferable to the other?, what's the difference in the
> three.
> Thanks
> Grumpy

Either of these should work from what I see on them.  The MM74HC161N-MM
part is a CMOS part so will be more suseptable to static discharge. 
Other than that they should both do the job.

Matt

References:
- ECM Bench kelp needed
  - From: "Bruce Plecan" <nacelp@bright.net>

Prev by Date: RE: ECM Bench kelp needed
Next by Date: Re: ECM Bench kelp needed
Previous by thread: ECM Bench kelp needed
Next by thread: Re: ECM Bench kelp needed
Index(es):
- Date
- Thread