Re: '730 ecu

["Programmer" <nwester@eidnet.org>]

If he can send me the *.bin, I'll make him up a *.ecu quick...

Lyndon.
-----Original Message-----
From: Swayze <kswayze@bellsouth.net>
To: gmecm@efi332.eng.ohio-state.edu <gmecm@efi332.eng.ohio-state.edu>
Date: January 19, 2000 5:27 AM
Subject: Re: '730 ecu


>What I've been doing is comparing
>several .ecu files for the
>aujp1350.bin(aujp.bin?). I am gradually
>correcting and changing a few things.
>what I hope to do next is to 'examine'
>the .asm from the archives and see if I
>can lock in the 'ranges' on the
>tables(0-80vs.0-100etc.) for this .bin.
>On a side note-- is there a generic .ecu
>file that will let TeamZR1 look at the
>.bin they have?(view in winbin).
>byE
>Mike S.
>
>Programmer wrote:
>> 
>> If you're unsure about the tables, use the graphical
>> part of the program. Count the humps--count the dots.
>> That's your table 9X10 size or "whatever" it is. Then you
>> can verify and design your own ECU files for ANY prom
>> you read. The spark and fuel maps are the easiest--the rest
>> is pick and find from similarities in other *.ecu maps.
>> 
>> Which one were you working on ??
>> 
>> Lyndon.
>> 
>> -----Original Message-----
>> From: Swayze <kswayze@bellsouth.net>
>> To: gmecm@efi332.eng.ohio-state.edu <gmecm@efi332.eng.ohio-state.edu>
>> Date: January 18, 2000 11:12 AM
>> Subject: '730 ecu
>> 
>> >Let me know if any of it works,
>> >the winbin .ecu file cleared up the prom
>> >edit format questions I had.
>> >one of the VE tables in the promedit is
>> >9x9 and 9x11(or was it 13?)in the winbin
>> >file.
>> >I have seen differences in the MAP axis
>> >labeling too.0-80 vs. 0-100kpa. is there
>> >a marker that shows the start of each
>> >table. Grumpy had mentioned a 3 byte
>> >header?
>> >byE
>> >Mike S.
>> >
>> >Programmer wrote:
>> >>
>> >> thanks Mike.
>> >> I've also heard acetone works great and doesn't
>> >> remove labelling.
>> >>
>> >> Lyndon.