Re: 7148 -> 7783 table locs

[JTesta1966@aol.com]

In a message dated 1/24/00 5:34:40 PM Eastern Standard Time, 
nacelp@bright.net writes:

<<  If someone could supply me with 7148
 | table location info I think it would be a snap.  Some of
 | you must have this ;)
  >>

If you mean a GN, (3.8SFI Turbo) Contact me privately

<<| Mike Pitts, if your listening, I unzipped Tweaker, but
| didn't dare install a w3.1 app on my NT.  Do you know
| if it works?  Also I didn't see chipster listed at MM
| online catalog. 

They no longer sell it.>>

Mike doesnt support tweaker any longer either. Hex Workshop seems to be the 
ticket :-)

<>

As far as I know, they ONLY do 86-87 GN's (dont know if its a 7148 ECM thing 
or not) They apparently WONT do 84-5 GN's so there MUST be something 
different)

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Jim Testa                                         TType86 on #BuickGN
jtesta1966@aol.com                               buick.fiendish.net:6667
ASE Master Technician            NJ Lic. Motor Vehicle Inspector
L1 Adv Eng Perf Certified     NJ Licensed Emissions repair Tech
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org