[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Auto learn code-Where?

To: gmecm@diy-efi.org
Subject: Re: Auto learn code-Where?
From: Tom Sharpe <twsharpe@mtco.com>
Date: Tue, 01 Feb 2000 22:13:15 -0600
References: <Pine.BSI.3.95.1000201114506.27944B-100000@horizon.hit.net>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

Great Idea!  Tom    let's build a scanner next.

Roger Heflin wrote:

>
> diacom/scantool data stream (code to disect the parameters) you could
> apply it to a large varity of GM type ecms.
>
>                                 Roger
>
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org

References:
- Re: Auto learn code-Where?
  - From: Roger Heflin <rah@horizon.hit.net>

Prev by Date: Re: DIY-EFI.ORG (was re: 2 bar map sensor)
Next by Date: Re: Auto learn code-Where?
Previous by thread: Re: Auto learn code-Where?
Next by thread: Re: Auto learn code-Where?
Index(es):
- Date
- Thread