Re: 2 bar map sensor

["nacelp" <nacelp@bright.net>]

They will sorta work.  But the pcm should set an error code.
The program will think the values are way out of line, since it is expecting
a 1bar MAP signal.
Grumpy



> Will the two and three bar sensors work on newer engines, such as the LS1?
> I notice those part numbers go back to some pretty old engines.
> Thank you.
> Michael
> > Anyway people are always asking about MAP sensors, part numbers, and
> > applications, it's all there now, go to www.diy-efi.org,
> > click on GMECM,
> > then click on "GM sensors".
> > --steve


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org