Re: [syclone bin]

[steve ravet <sravet@arm.com>]

Dig wrote:
> 
> "John S. Gwynne" <jsg@jsgpc.mrcday.com> wrote:
> > Bruce has a 2 bar Syclone bin ("latesycl") that I disassembled and
> > correlated to the axxc/anht bin. Out of a little over 6000 lines of
> > assembly, only about 900 lines correlated. the factory test mode were
> > basically the same along with most of the table lookups and such in
> > high memory. I placed the results at
> > <ftp://jsgpc.mrcday.com/pub/gmecm/latesycl.S>. The comments in this
> > come from the ECMGUY's disassembly of the anht bin.  If anyone has a
> > good commented disassembly of this code, send it to me. I would like
> 
> I've been working on it in bits and pieces. Here's a chunk of boost code
> @ e62d. My Diassembler is quite a bit different from yours, but I like
> the way it lets me bulk-enter the symbols.

What disassembler are you using?

--steve


-- 
Steve Ravet
steve.ravet@arm.com
Advanced Risc Machines, Inc.
www.arm.com
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org