Re: Crossfire injectors.

["nacelp" <nacelp@bright.net>]

ATL used to sell chunks of fuel cell material.  Make a screen surrounding
for the sender, and install after the chucks of cell.  Light, and looks oem.
BTW, the is an outfit that advertises in I think it was Hot Rodding that
does make custom tanks with baffles
Grumpy

> "The best solution for a fuel tank (and pump) would be to find a suitable
donor
> from a fuel injected car. These would have baffles and an in-tank pump. I
> jerry-rigged a baffle for my tank and will share that only if it turns out
to be
> OK. Confidence in my rig is still low. "
>
> I am trying to install an EFI system on my BB '67 coronet.  I was going to
have
> the gas tank boiled, and weld a rear sump in the car, using an external
pump
> from ACCEL (#74701 - 400hp).  I figured I can run the tank down to about
an 1/8
> before running into sucking air.  The only baffling I was going to do
would be
> via the instructions with the sump.  Drill five or so 1" holes in the
bottome of
> the tank, place sump over them and weld.  Of course the tank will have
been
> cleaned (professionally) and dried for many days prior.  What was your
final out
> come? did it work?  what would you do different next time?  Unfortunately,
due
> to the arrangement and style of the gas tank, i couldn't find a new tank
with
> baffles and in tank pump that would fit, so that is not an option...
>
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org