Re: [Re: [syclone bin]]

[Tom Sharpe <twsharpe@mtco.com>]

could you send me a sample of your .dat file/  TIA  Tom

Dig wrote:

> steve "chili sauce" ravet <sravet@arm.com> wrote:
> >
> > > I've been working on it in bits and pieces. Here's a chunk of boost code
> > > @ e62d. My Diassembler is quite a bit different from yours, but I like
> > > the way it lets me bulk-enter the symbols.
> >
> > What disassembler are you using?
>
> It's a little DOS-based one called dis6811, written by JR Shifflet.
> I found it (him) about 7 years ago, and he was even good enough to
> send me the source code. He also taught me how to read MOT assembler,
> since I was an intel-boy at the time.
>
> It accepts a .dat file for all the sybols you care to enter, program
> entry points, and the like. The only "downside", is that it takes quite
> a bit to get the code to a re-assemblable format, since it keeps all the
> location info.
>
> The only thing he asked for was that I didn't re-distribute it without
> checking with him first. I wish I could find him again, because I've had
> a fair amount of interest in it.
>
> Later,
>
> Dig
>
>
> ____________________________________________________________________
> Get free email and a permanent address at http://www.netaddress.com/?N=1
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org