RE: DP Ram Emulator...

[Eric Aos <EOA@spartek.com>]

> 
> To get the reduced power consumption of standby mode, all 
> inputs to the
> DPRAM must be at essentially GND or whatever the VCC voltage is.  This
> generally means that you need to have pulldown resistors on all bus
> lines.  (You could use pullups to the battery voltage, but then you'd
> have leakage into a powered down ECM.)
> 

Just dropping the CE won't do it then? Will the ECM be ok with pulldown's on
it's lines?  

Eric
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org