Re: Conversion table

["Programmer" <nwester@eidnet.org>]

What kind of scan tool ? Usually there's a setup
screen with your viewing options.

Lyndon.
-----Original Message-----
From: Ramsey Foster <ramsey_foster@mensor.com>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: February 11, 2000 7:32 AM
Subject: Conversion table


>Hi,
>
>I'm new to the list so please forgive if I'm covering old ground.  I have
>searched the archives for this info, but unsuccessfully.
>
>I am looking for a conversion table or factor to change voltage output from
>a GM TBI MAP to kPa.  The scantool I have only outputs the sensor data in
>voltage, but my programmer is having difficulty referencing this data to
the
>tables we need to change as they are based on kPa readings.
>
>TIA,
>Ramsey
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org