Re: Diacom problems on Thinkpads (Was Re: 88 TBI issue)

[Barry Tisdale <btisdale@cybersol.com>]

Make sure your ALDL wiring is up to par; I had a bad ground connection to
the sheet metal *and* to the engine block.  Adding a *good* ground wire(s)
solved the problem.  Measure the resistances; should be darn close tp zero.

Barry

At 06:27 PM 02/11/2000 -0500, you wrote:
>Tom, Diacom works fine on my Toshiba T1000XE.  Recently, I have been using
>a Thinkpad 760C and also noticed the inability to link with a 8192 baud
>source (1990 3800).  When connected to a 160 baud ECM (1228330),
>I have observed intermittent errors: out of range data or trouble codes
>specific to one frame.  There's about 4 or 5 obvious errors in a 200 frame
>capture.  Does anyone have a possible explanation or workaround?  Thanks.
>
>Kevin Wong         mailto:brougham1@home.com         Toronto, Ontario, Canada
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org