RE: knock sensor/solid cam

["Jim Sloan" <leroy@sunflower.com>]

How are you planning on getting the timing table accurate?  Just
wondering...

Jim Sloan
leroy@sunflower.com

> -----Original Message-----
> From: owner-gmecm@diy-efi.org [mailto:owner-gmecm@diy-efi.org]On Behalf
> Of Jeffrey Scott
> Sent: Wednesday, February 16, 2000 3:56 PM
> To: gmecm@diy-efi.org; gmecm@diy-efi.org
> Subject: Re: knock sensor/solid cam
>
>
> The reason for asking was, I already have a motor with solid cam
> and will be adding FI with syty computer.  I plan on getting the
> timing table accurate so a KS isn't needed, and didn't even plan
> on installing one to start with, but wanted to know if I did
> install a KS would it work or cause problems.
> ---
> Jeffrey Scott
> JWS6367@mailcity.com
> NWSTP founding member (1of2)
> ICQ #25436277
> 92 ty#1295  black/black
> 67 Camaro
> 63 Nova
> http://www.geocities.com/baja/dunes/9423
>
>
>
>
>
>
> On Wed, 16 Feb 2000 15:48:16   nacelp wrote:
> >There really ain't too much to be gained over a good hydralic, for the
> >street.  If racing ya oughta have calibrated it better and not
> rely on the
> >KS.
> >  I've had several cammed motors work fine, and a couple that were
> >absolutely impossible not to ignore the KS.
> >  Remember only in the losest of terms is it a KS.  It's a
> microphone, and
> >any generator of the right frequency sets it off.  I've had a serpentine
> >belt cause a false signal
> >Grumpy
> >
> >
> >
> >> Has anyone used a knock sensor on a solid cam engine?  Will it
> have a lot
> >of False knock, or is the freq. different than the filter picks as knock?
> >> Jeffrey Scott
> >> JWS6367@mailcity.com
> >
> >
> >-----------------------------------------------------------------
> -----------
> >To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> >in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> >
> >
>
>
> MailCity. Secure Email Anywhere, Anytime!
> http://www.mailcity.com
> ------------------------------------------------------------------
> ----------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org