[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Debugger board for P4 ECMs



This sounds excellent to me.  I would definitely buy a couple.  Oh, and
I'd like the RS-232 version please...  Could the software for it be put
into a flash or EPROM and mapped into unused ECM address space?

--steve

Ludis Langens wrote:

> I can dump and alter memory, I/O, and registers including the PC.  I can
> also run simple programs written in an interpreted language.  There's
> currently no disassembler because all code in the ECM is part of the
> debugger.  It's easy enough to work from a listing instead.  Plus, a
> desktop system could do a much better job of disassembling.  There's
> also no single step because the P4/HC11 doesn't support that in
> hardware.  There are tricks to single stepping on such systems.  I now
> know enough about the P4 hardware to try one.

-- 
Steve Ravet
steve.ravet@arm.com
Advanced Risc Machines, Inc.
www.arm.com
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org