Re: Debugger board for P4 ECMs

["Swayze" <kswayze@bellsouth.net>]

so can the same program be created with something like basic11 for a 68hc11 or could a VB like script be used.

> I can dump and alter memory, I/O, and registers including the PC.  I can
> also run simple programs written in an interpreted language.  There's
> currently no disassembler because all code in the ECM is part of the
> debugger.  It's easy enough to work from a listing instead
...................
>serial interface to a laptop separate from the ALDL interface.  This
>would require grafting debugger software onto GM's software.

this i'm assuming would be a patch to the control software in the MEMCAL.
Swayze
mswayze@truswood.com
kswayze@bellsouth.net


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org