Re: Plug reading

[David Cooley <n5xmt@bellsouth.net>]

At 10:32 AM 3/7/2000, you wrote:
> Hmmm....Is the MAF contaminated ? It'll make this thing
> run on the lean side. Any pinging ? Are you monitoring
> with a scan tool during the runs ? Using the dual plats ??

Cleaned the MAF about 2 hours before the run.  No pinging, Using Alex 
Pepers OBD-II scantool.
O2 volts seems to stay between 880mV and 950mV at WOT.
Using stock dual plat plugs, factory recommended gap.

===========================================================
David Cooley N5XMT Internet: N5XMT@bellsouth.net
Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
We are Borg... Prepare to be assimilated!
===========================================================

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org