[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: GM Powertrain



MEFI3 system is sold with the Ram-jet engine pictured on the front of
the 2K GM Perf. Parts book.  Small problem, the engine and all it's
parts are not yet available.  And I haven't been able to find out when
it will be.  The makers of Diacom, Rhinda (sp?), have worked with MEFI
and offer some calibrations software for it.  I'd be interested in
anything that you might find out about the system.
Shannen
 
nacelp wrote:
> 
> Except for some marine manufacturers, and a limited number of folks involved
> with oem calibrations, I don't know of anyone who has actually even seen one
> yet.  I think the gm advertising group got way ahead of the production
> folks.  Also, I've just seen it mentioned with the Retrofit system, might
> not even be available seperately, or for a while.
> Grumpy
> 
> > I'm new to the list and looked through the archives and did not find
> > much information in regards to the MEFI3.
> > I'm looking to see what can be done in regards to configuring the unit
> > for use on a cylinder.
> > I see that they offer a setup for use with a distributor.
> > Does anyone know if it can be done DIS with wastefire? or DIS with coil
> > per cylinder?
> > Is there a site that I can get good information about the setup? Or does
> > anyone on the list have information that they can send me?
> > Thank you
> > Ken Bauman
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org