Re: 4L60E Trans controller/Ward

["gene l. clifford" <genelc@idworld.net>]

nope I sure don't expect U to baby sit but if u were to direct me to the
proper sources
I would be most grateful??
anyway I still am not sure that  U  have answered my question provided I
find this "p6" unit will I have to work on it or will it be usable as is??
forget the perfomance angle for the moment!
                                                   Gene
---- Original Message -----
From: "Ward" <WSpoonemore@excite.com>
To: <gmecm@diy-efi.org>
Sent: Thursday, March 09, 2000 8:48 PM
Subject: Re: 4L60E Trans controller/Ward


>
> Any late model truck would be a good start, say 93 th 95 C/K truck
> would be a good start.
>
> Cost about $80 exchange  probalby lt @200 outright.
> Shurly you don't expect me to instruct you via e-mail on programing?
>
> There is comercial software avialble for these trucks.
>
> Ward
>
>
> On Thu, 9 Mar 2000 15:41:07 -0600, gmecm@diy-efi.org wrote:
>
> >  Ward please tell this poor newbie what a  "P6 processor" is? Where do I
> get
> >  one,cost and do I have to program it or is it ready to use
> >                                                Gene
> >
> >
> --------------------------------------------------------------------------
--
> >  To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
> >  in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> >
>
>
> Ward
>
>
>
>
>
> _______________________________________________________
> Get 100% FREE Internet Access powered by Excite
> Visit http://freeworld.excite.com
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org