[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

MAP signal dampening

To: <gmecm@diy-efi.org>
Subject: MAP signal dampening
From: "Swayze" <kswayze@bellsouth.net>
Date: Fri, 10 Mar 2000 14:31:47 -0500
References: <0907A01D587ED311BC63009027A19CC53A8856@mpd2-nt4.meridian-mag.com>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

will remote mounting a map sensor (attached to manifold with vacuum hose)
dampen some of the idle fluctuations or average out the MAP signal?  If so,
what is the proper ID tubing?
byE
Mike
Swayze
mswayze@truswood.com
kswayze@bellsouth.net

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org

Follow-Ups:
- Re: MAP signal dampening
  - From: "nacelp" <nacelp@bright.net>
- RE: MAP signal dampening
  - From: Carl Summers <InTech@writeme.com>

References:
- RE: 89 F-body ECU file = 89 Y-body ECU file?
  - From: Mike Rolica <mrolica@meridian-mag.com>

Prev by Date: HEI
Next by Date: Re: MAP signal dampening
Previous by thread: RE: 89 F-body ECU file = 89 Y-body ECU file?
Next by thread: Re: MAP signal dampening
Index(es):
- Date
- Thread