Re: LS1 in 64 Impala SS

["alexpeper" <alexpeper@email.msn.com>]

Yes, if 16 pin d-shaped connector, will translate rs232 into J1850 VPW
I sell scan tool software with the hardware interface $122.  I have not
worked on any reprogramming with this interface.
Alex C. Peper
http://www.obd-2.com
----- Original Message -----
From: Dave & Irina Eicher <sailors@mwci.net>
To: <gmecm@diy-efi.org>
Sent: Saturday, March 18, 2000 6:59 PM
Subject: Re: LS1 in 64 Impala SS


> What do you charge for that hardware, and what does it do? Does it allow a
> PC serial port to be connected to the ALDL for an LS1 PCM?
>
> thanks,
>
> dave
>
> ----- Original Message -----
> From: alexpeper <alexpeper@email.msn.com>
> To: <gmecm@diy-efi.org>
> Sent: Saturday, March 18, 2000 2:52 PM
> Subject: Re: LS1 in 64 Impala SS
>
>
> > Yes, common to obd2 messages is a 3 byte header indentifying
> > priority, source and destination.
> > Alex
> > ----- Original Message -----
> > From: Dave & Irina Eicher <sailors@mwci.net>
> > To: <gmecm@diy-efi.org>
> > Sent: Saturday, March 18, 2000 8:25 AM
> > Subject: Re: LS1 in 64 Impala SS
> >
> >
> > > Hi Alex,
> > >
> > > Really, knowledge of the hardware would be a good start. Do you
suppose
> > the
> > > reprogramming message structure is at all related to the message
> structure
> > > of the data coming out of the PCM?
> > >
> > > thanks,
> > >
> > > dave
> > >
>
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org