Re: LS1 in 64 Impala SS

["alexpeper" <alexpeper@email.msn.com>]

I will add provision to manually enter messages and send them.
This is a requirement for a fully compliant obd2 scan tool.
Alex

----- Original Message -----
From: David Cooley <n5xmt@bellsouth.net>
To: <gmecm@diy-efi.org>
Sent: Monday, March 20, 2000 8:15 AM
Subject: Re: LS1 in 64 Impala SS


> Alex,
> Do you have any software for your scantool that allows the "raw" data to
be
> played with for experimental purposes, Or specs on your hardware so
someone
> could write something to play with for programming etc?
>
>
>
> At 01:43 AM 3/20/2000, you wrote:
> >Yes, if 16 pin d-shaped connector, will translate rs232 into J1850 VPW
> >I sell scan tool software with the hardware interface $122.  I have not
> >worked on any reprogramming with this interface.
> >Alex C. Peper
> >http://www.obd-2.com
>
> ===========================================================
> David Cooley N5XMT Internet: N5XMT@bellsouth.net
> Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
> We are Borg... Prepare to be assimilated!
> ===========================================================
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org