Re: added baro sensor to 730

["nacelp" <nacelp@bright.net>]

Kewl, thanks
Just a note thou what do you mean by GF14?.  The pinout table I have Shows
A-F, no GF, or is this some other way of id'ing where the sensor attachs?.
If so could I have in dumb guy lanauage?.  I assume your using the normal 5V
that is ecm supplied?
Thanks Again
Grumpy

> In following up on the VE stability I posted of last week, I've shown
> that the baro error can easily make several percent VE error when the
> code is left stock and a supercharger is added.
> To address this, I elected to add a second MAP sensor and patch the
> code. Power and ground are attached identical to the original sensor,
> and the signal is attached to GF14 (a/d channel 0).
> The patched code can be found at
> <ftp://jsgpc.mrcday.com/pub/gmecm/axxc.S_032000>


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org