Re: Driving an HEI Module with other signals

[Bob Valentine <bob@tecmark.com>]

At 05:33 PM 3/23/2000 +1100, you wrote:
>I'm wondering if it's possible to drive an HEI (High Energy
>Ignition) module with other than a reluctor pickup coil.
>The HEI module I'm thinking of has three groups of connectors:

>I'm wondering if it could be made to work with an existing
>mechanical points, and an interface/translator circuit.

Wired directly to points it seemed to have problems at higher rpm's when I
tried it.   Yes, I did remove the condensor.   A Mopar box has no trouble
running directly from points.

>Or, perhaps made to work with a hall effect/optical sensor?

Never tried it.


--> Bob Valentine
--> bob@tecmark.com

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org