[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: GM 4 cylinder DIS



I use the Needhams (try   www.needhams.com) someone posted they had scratch
and dents for like 100, and a Dataraser II (UV eraser) for like $50 (get the
one with the timer).  After better part of a thousand erase cycles mine
needs a bulb.
   Some one has posted about using a 747 as a ignition controller, ie not
doing fuel.  Researching that will give ya a good foot hold on this stuff.
The 747 is also what Programming 101 is about....
Grumpy


> >For all the work to do that it would be alot easier in my book to >just
do
> >the ecm work, for ignition control.
> >If you look at some of the timing maps (yes you'd have to download >the
zip
> >archives and hunt), but you'll see that it would take a TON >of work to
get
> >the same curves with anything else.
> >
>
> Alright, thanks for the reply.  Another fellow has already done the setup
> with the microcontroller, and I was hesitant, knowing that the work was
> already in the ECM.  I downloaded the archives last week and am a quarter
> way through them.
>
> >Slightly over a hundred, and with shopping right at.
> >Get a Needhams's and be done with it.  You probably could get most >of
you
> >money back out of it from someone on the list if you quit.
> >
>
> Whoa!  I think I was missing something, but last week I thought the talk
was
> several hundred dollars for equipment.  I don't have the emails in front
of
> me now.  If it will only cost me a hundred or two, then I'm all for it.  A
> microcontroller on a board is already going to costs me $75 or more and I
> still have to program it.  Again, I will check the archives and do more
> research.  At least with the ECM, I would potentially have the option of
> going to FI when I felt comfortable with what I am doing.
>
>
>
> >You can do, just an ignition only ecm.   Then add the Fuel to it later
> >Grumpy
> >
> >Hold off doing anything till your really sure of what you want to do.
>
>
> Thanks again.  I need to do some homework before I come back here again.
> This sounds very promising.
>
> Jay
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org