Re: V6 ALDL Communications

["nacelp" <nacelp@bright.net>]

Did you set mode to normal before linking?.
Grumpy


> >I'm fairly certain that
> >the car is looking for a 3.9 k resistor.  However when I set my cable to
> >such the car goes beserk!  3000 rpm idle.  Codes 33 and 35, and still no
> >data.  The car will barely run with this resitor!
>
>
> I don't know what is going on Jeremy, but I've seen this with my 83 T/A,
> I've had Diacom on this car a few times and after several minutes the car
> idles at 2500RPM!!.
> Pull the cable out and it's fine?.
>
> Ross Myers
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org