Re: 7749 guru needed....

["TK" <terryk@foothill.net>]

The Syty code has a VE table for closed throttle.

>
> I don't know about the SyTy code, but several other ECMs have yet
> another table for idle VE.  The rows/cols of this table are in finer
> increments than the main VE table.  This extra table overlays the "idle
> corner" of the main VE table.  This means that a few entries in the main
> VE table are never used.  Perhaps that's why you aren't seeing any
> changes from zeroing out the four locations.
>
> --
> Ludis Langens                               ludis (at) cruzers (dot) com
> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
>
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org