Re: Novice Question

["nacelp" <nacelp@bright.net>]

I've heard of folks disassebling the memcals, but I have yet to do anything
other then wreck them with any attempt I've made at that.  Also, remember
some of these guys do this stuff for a living and have the hands of a
surgeon, and the proper equipment for doing said operations.  I've seen a
doctored PCB, that I had to ask where the work was done, it was that good.
If you do that sort of thing fine, this is just a broad spectrum letter, so
that not everyone thinks it's a no brainer to do.

Like the electrictian said to the surgeon, how dare you charge so much for
what you do, I do things just as finely, and acurately as you.  The surgeons
response,     ya but I do my work on stuff that is alive.
Grumpy


> I thought Shannen meant you could get the little chip on the memcal from
the
> dealer..   I guess I missed the apple or was it an orange.  Though with
the
> number of memcals I have from the 'spare' ECM's I think its worth the time
> trying to get the six cyl version to work in the eight as a recent post
> about pin 56 of the memcal
>
> Thanks for the correction, though its not what I wanted to hear;-)
> Max
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org