[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Novice Question



Get to Rat Shack, get the 15W soldering iron with the sharp tip. It's
perfect for desoldering the memcals.  I don't even have to lift the
prom first...  New proms fit right in, and the iron is good for
resoldering the terminals.
Shannen

nacelp wrote:
> 
> I've heard of folks disassebling the memcals, but I have yet to do anything
> other then wreck them with any attempt I've made at that.  Also, remember
> some of these guys do this stuff for a living and have the hands of a
> surgeon, and the proper equipment for doing said operations.  I've seen a
> doctored PCB, that I had to ask where the work was done, it was that good.
> If you do that sort of thing fine, this is just a broad spectrum letter, so
> that not everyone thinks it's a no brainer to do.
> 
> Like the electrictian said to the surgeon, how dare you charge so much for
> what you do, I do things just as finely, and acurately as you.  The surgeons
> response,     ya but I do my work on stuff that is alive.
> Grumpy
> 
> > I thought Shannen meant you could get the little chip on the memcal from
> the
> > dealer..   I guess I missed the apple or was it an orange.  Though with
> the
> > number of memcals I have from the 'spare' ECM's I think its worth the time
> > trying to get the six cyl version to work in the eight as a recent post
> > about pin 56 of the memcal
> >
> > Thanks for the correction, though its not what I wanted to hear;-)
> > Max
> >
> > --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> >
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org