[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

manifold machining

To: <gmecm@diy-efi.org>
Subject: manifold machining
From: "Thomas Matthews" <tmatthew@stny.lrun.com>
Date: Thu, 6 Apr 2000 23:54:28 -0400
References: <01BF9FC6.DC5A2720.Webmaster@lotus-carlton.fsnet.co.uk> <38ED381E.95586625@clarityconnect.com>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

Anyone know anybody that can machine the holes and weld the bungs for a carb
to EFI conversion on a Torker 2, and the price? I have the rails and
bungs...
Rance wants $500 and I think that's a lot steep...
Any suggestions/thoughts/recommendations?
That's the last part of my EFI retrofit to do...
thanks
Tom

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org

Follow-Ups:
- Re: manifold machining
  - From: "nacelp" <nacelp@bright.net>
- Re: manifold machining
  - From: Frederic Breitwieser <frederic@xephic.dynip.com>

References:
- RE: Turbo MAP & MAT interaction
  - From: Webmaster <Webmaster@lotus-carlton.fsnet.co.uk>
- Re: Turbo MAP & MAT interaction
  - From: Scot Sealander <Sealand@clarityconnect.com>

Prev by Date: Re: Quad-4 (1228707 ECM) Rough Idle Problem
Next by Date: Re: manifold machining
Previous by thread: Re: Turbo MAP & MAT interaction
Next by thread: Re: manifold machining
Index(es):
- Date
- Thread