Re: manifold machining

[Frederic Breitwieser <frederic@xephic.dynip.com>]

> Mr Natch' says "use the right tool for the job"!

Usually, yes, however often one can "get away" with having a darn close
tool rather than the right tool.  To drill bungholes on your intake, a
mill is a better choice.  That's the -right- too, but I assure you, it
can be done on a drill press with the right bit.

Though, tools are good karma, so its a good excuse to buy a Smitty, or
equivilent :)

-- 

Frederic Breitwieser
Xephic Technology
769 Sylvan Ave #9
Bridgeport CT 06606

Tele: (203) 372-2707
 Fax: (603) 372-1147
Web: http://xephic.dynip.com/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org