Newbie

[DarthOlds@aol.com]

Hi, 
New to this list, and a GM owner.
I've read a few post/replies and am so far lost. So for the time being I'll 
just hang out and lurk. I just want to learn a little more before I open my 
big mouth. 
A little about me now.
I'm a long time member of the Oldsgmail list (also on Majordummy).
I'm an Olds man. I have an 83 Cutlass Supreme project car, and 84 Cutlass
daily driver. I want to use a port FI setup on my Olds motor. So I need to 
know more about the GM computer. I figure this is the best place to start.
Here's the deal, I read an article in HotRod about a 55 Olds with TPI Olds 
368.
I want to do the same, only with my 307. I'm going to have a sheetmetal 
intake built,
and have Lingenfelter install the injector bungs and fuel rails. I will use 
the throttle
body, injectors, and ECU from a 305 TPI unit I salvaged from my wife's 85 TA.
Well, that's the plan. I think it would help me to learn more about ECU in 
case
I need to have a Prom Burned or if I learn how to do it myself.
Any ideas, comments, or thing I should know?
Looking forward to learning a lot.

dvaderolds
Kevin White
83 CSB FE3X clone in resto mode
83 CS The daily driver
 <A HREF="http://members.xoom.com/dvaderolds/cutlass.html";>MY 83 Olds Cutlass<
/A> 
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org