Re: It's alive!

["nacelp" <nacelp@bright.net>]

One of the reasons I went to pintles with different tapers.  But, that was a
mechanical answer to a software problem.
Grumpy

> Well. . . I wouldn't say it's drivable yet, however, it's getting there.
> Still working on getting a good idle, tends to be rich. Halved the
> injector constant and reduced the fl2 table by 15%, still a bit rich,
> but better. Both int & blm sitting low.
>
> The strangest thing is the IAC opening on a pedal blip, then taking
> it's time closing (~4secs). Causes the r's to hang.
>
> Later,
>
> BobR.
>
> mike mager wrote:
>
> > BobR. said:
> >
> > >It runs! Another success story directly attributable to the list.
> >
> > Hey, cool!
> > Sounds like it's running pretty well?  I'm not paranoid, but I always
check
> > the ECT a few extra times.
> >
> > >More to come. . .
> >
> > No teasing!
> >
> > Mike
> > ______________________________________________________
> > Get Your Private, Free Email at http://www.hotmail.com
> >
>
> --------------------------------------------------------------------------
--
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org