Re: Trouble with Pocket Programmer

["Jeff Kopp" <jkopp@direcpc.com>]

Roger,

The Pocket Programmer I have says it is made in Edwardsville, KS (just
outside K.C. area a bit).  Also, thanks for the info on the Text instead of
HTML.  I don't usually have it set for HTML, but it was so I switched it
back.

-----Original Message-----
From: Roger Heflin <rah@horizon.hit.net>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: Sunday, April 16, 2000 10:08 PM
Subject: Re: Trouble with Pocket Programmer


>
>I have not had any problems with mine.  I did have one that did what
>you describe, it did that after I plugged the transformer for the
>eraser (20V) into it.   I am made sure since then not to make that
>mistake again.   I am not counting that as having problems with it
>since I made the mistake, by pluggin in the wrong transformer.
>
>Where is the PP made?I thought it was made about 3-4 hours from where
>I am.
>
>One suggestion, you might set your email proram to not send html
>messages, send text messages, alot of the lists will get unhappy with
>html messages.
>
> Roger
>


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org