Re: VE#1 + VE#2 can I zero ve#2 until 3200 rpm??

[Ludis Langens <ludis@cruzers.com>]

olbap wrote:
> 
>   Would there be any adverse effects if i just zero'ed VE#2 up till 3200 rpm
> since they both add anyways? Then fill in from 3200 on up to get the upper
> rpm stuff right. Just seems to me like it would eliminate some hassle
> balancing two tables for no reason in the primary driving zone.

It won't work, you can't set it up that way.  Think about it a bit. 
Remember, the 3200 rpm value of the main table gets used for for all
rpms 3200 and up.  Follow GM's lead: fill the VE2 table with a constant
value through 3200 rpm.  Actually, you may need some variation in case
your table values need to go negative - they can't be negative, so you
have to adjust everything else.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org