[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: VE#1 + VE#2 can I zero ve#2 until 3200 rpm??



At 09:42 PM 4/18/00 -0800, you wrote:
>olbap wrote:
>> 
>>   Would there be any adverse effects if i just zero'ed VE#2 up till 3200 rpm
>> since they both add anyways? Then fill in from 3200 on up to get the upper
>> rpm stuff right. Just seems to me like it would eliminate some hassle
>> balancing two tables for no reason in the primary driving zone.
>
>It won't work, you can't set it up that way.  Think about it a bit. 
>Remember, the 3200 rpm value of the main table gets used for for all
>rpms 3200 and up.  


Yeah I had thought of this, so at 3200 rpms is where i would start adding
them together
the main table would invariably have a lower number across the board at 3200
since it would always be added to the second table at 3200 and up. Maybe I
am overlooking something?  What I am looking for is a constant though so i
could just end up using 10  or some other random number if I cant use zero.
Thanks for pointing that out and refraining from putting Duh at the end :)

Pablo

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org