Re: Temp sensor

[Mike Dillon <mdill@lsil.com>]

Hi All,

>From looking a the Delpi a while back I seem to remember that all the
Delpi sensors were functionaly the same (same resistance/temp responce)
They just packaged them in alot of different ways. I anyone can confirm 
this it may allow a much wider choice as far as packaging goes.

Mike D.  


Date: Tue, 18 Apr 2000 08:27:49 -0400
From: "Peter D. Hipson" <mail@darkstar.mv.com>
Subject: Re: Temp sensor

The 4L80E one is easy to get at, just drop the pan, it is hanging off the
wireing harness. However, it may be easier to just go to Radio Sludge and
get a thermistor. If you want I can look up the 4L80E specifications for you.

At 10:40 PM 4/17/2000 EDT, you wrote:
>The 4L60-E does have a temp sensor. It is part of a PSA pressure switch 
>assembly. The part is about 6 inches by 3 and the sensor part looks like a 
>thermister just suspended in the middle of it. I don't know if you could get 
>it out intact. I'll check into the one for the 4L80-E
>AL
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
>
Thanks, 
        Peter Hipson (founder, NEHOG)
        1995 White NA Hummer Wagon
- 
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org