RE: 2 bar MAP on a ZR1?

["Malcolm Robb, LC 0112G" <Webmaster@lotus-carlton.fsnet.co.uk>]

My Lotus Carlton uses the 1228331 ECU which I believe is the same as the 
ZR1's. The MAP sensor on that is a 2 BAR one according to the workshop 
service manual (fuel injection is inhibited at 1.98 Bar to prevent the head 
gasket / block exploding if the wastegates fail on the turbos !) If no-one 
else has any better ideas, then using the bin from my car may be a starting 
point ?!  Its on the incomming ftp as 91_Lotus_carlton.bin

Cheers,
Malcolm Robb, LC 0112G

-----Original Message-----
From:	Jason R. Haines [SMTP:jhaines@lingenfelter.com]
Sent:	Monday, May 01, 2000 10:20 PM
To:	GMECM
Subject:	2 bar MAP on a ZR1?

 << File: ATT00001.htm >> Anyone have any ideas on how to convert a GM LT5 
(ZR1) P4 ECM/PROM to accept a 2 bar MAP?


Jason


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org