[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 165 ECM question, "single fire" vs "double fire"



My reading of the code is that unless single-fire mode is turned
on by bit1 of address 0xC014, that double fire mode will be the
default..  In the ARAP base I use, bit1 is turned off and double-fire
inj settings should be used..

mike

In message <Pine.LNX.3.95.1000505080918.12668B-100000@yyy.esper.com>,Kevin Crai
n writes:
>Thanks Ludis, this clears things up!  Back to the original question
>about which variable the ECM uses to calculate pulsewidth...is it the
>'single-fire' at location 3D7 or 'double-fire' at location 3D9?
>
>-Kevin
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org