[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IAT / MATs




> Anyone have a lead on a 3/8" pipr to 1/4" pipe thread reducer that is non
> metallic?.
> I want to isolate the sensor as much as possible from the heat soaking of
> the engine.
>
> BTW, the high end of the syty timing mat correction is 130.  So guess
what?.
> again ya run outta correction.
> Brumpy
>
Bruce ,

Where are you getting the 130 figure from?

Jim Sloan
leroy@sunflower.com



----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org