Re: First chip ready

[Shannen Durphey <shannen@grolen.com>]

trax wrote:
> 
> >Don't try to save the chip. Cut it out leg by leg, then desolder the
> >remnant of each leg.
> 
> Agreed.  But, I'll modify this a little bit :-)
> 
> I was originally going to desolder the chip.  Then I thought that with my
> clumsy hands that I would screw something up.  So, here is my plan...
> 
<snip>

> 8) Solder a low profile ZIF into the memcal.

I've been using a "regular" eprom socket in my bench ecm for a couple
of months now.  There's been many chip changes, but the socket still
seems good.  Plus the cover can be closed.
Shannen

> 9) Burn a new chip with the previous image (or the modified image).
> 10) Put the new EPROM in the ZIF
> 11) DONE!
> 
> Tim Siford
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org