Re: Reorted O2 volts

[Bob Valentine <bob@tecmark.com>]

Reading a '91 Cavalier shop manual, it says that the ECM supplies .450
volts on the 02 sensor wire; this contradicts everything I've read since I
thought you NEVER apply any voltage [even current limited] to the 02....  

-> Bob Valentine
-> bob@tecmark.com

At 05:01 PM 5/10/2000 -0400, you wrote:
>Was just playing with the ecm bench witha 1227749 and basically stoock chip.
>Just some flags turned off.
>
>All comments reference Diacom,
>
>With the O2 lead disconnected the O2 reported by diacom, key on, no run,
>about 450 and wandered slightly, and flickered to .5.
>
>With the O2 input tied to ground thru a 100K resistor was aout 4 millivolts
>
>The O2 reported voltage was about .01 higher then actual.  But, this ain't
>lab grade metering
>Grumpy
>
>
>
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org