Re: Quad 4 code

["nacelp" <nacelp@bright.net>]

----- Original Message -----
From: Shannen Durphey <shannen@grolen.com>
To: <gmecm@diy-efi.org>
Sent: Friday, May 12, 2000 7:32 PM
Subject: Re: Quad 4 code


> Soo... you're looking for a 4 cyl app for the 749?  You've tried
> ANHT?  If you're running with a dizzy, how about the turbo sunbird
> calibration?
> Shannen
>
> cwagner@info2000.net wrote:
> >
> > Has anyone done any work with the code from the 88 Quad 4
> > setup using the 749 computer?  I was going to use the ANHT code
> > from a 90 Corvette but something in the code changes when the
> > injectors fire.  I am putting this on a 4 cyl engine and if I used the
> > ANHT code, the injectors would fire once ever other rev of the
> > crankshaft.  That is unless someone nows how to change things in
> > the ANHT code to fire the injectors once every rev of the crank.  I
> > am out of ideas.  By the way, I am using the memcal from a 749
> > Quad 4 so I now that is not the problem because I tested it without
> > the eprom(limp-home).  The computer is a 730.
>
> --------------------------------------------------------------------------
--
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org