Re: Quad 4 code

["nacelp" <nacelp@bright.net>]

> Has anyone done any work with the code from the 88 Quad 4
> setup using the 749 computer?

Er, no but I've played around with some ecms.

  I was going to use the ANHT code
> from a 90 Corvette but something in the code changes when the
> injectors fire.

Ya, cylinder select, and memcal determine that.

 I am putting this on a 4 cyl engine and if I used the
> ANHT code, the injectors would fire once ever other rev of the
> crankshaft.  That is unless someone nows how to change things in
> the ANHT code to fire the injectors once every rev of the crank.  I
> am out of ideas.

???.   I'm misssing something here, isn't this the same question?.

By the way, I am using the memcal from a 749
> Quad 4 so I now that is not the problem because I tested it without
> the eprom(limp-home).  The computer is a 730.

Pinouts change from 730 to 749
need to visit Ludis Site
Grumpy
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org