[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: A few lt1 ?'s



Just so you know this is a 96 lt1 out of a caprice going into a 72 chevy
p/u. So when i hit the brake 12v need to go to the tcc wire. i could just
tap into my breaklight right? thanks

Mike
----- Original Message -----
From: <Chipsbyal@aol.com>
To: <gmecm@diy-efi.org>
Sent: Friday, May 12, 2000 8:15 PM
Subject: Re: A few lt1 ?'s


> Run your electronic speedo from the PCM. If this is a chip application for
> the LT1, the speedo sensor at the trans needs to be the correct gears for
the
> tire and rear end ratio. The MAF system, PCM type gets calibrated at the
PCM.
> The p/n switch is grounded in park and neutral.
> The brake switch wire interrupts the positive side of the circuit on the
chip
> type (700R4). The brake switch wire on the PCM system "tells" the PCM to
> disengage the TCC. The solenoid gets its feed from a common power input to
> the 4L60-E. In both systems, the computer has total control of the ground
> side.
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org