Re: A few lt1 ?'s

["Mike" <itsmike@lvcm.com>]

ok i dont mean to be a pest.:) But when the brake is applied 12v is sent
through the purple wire to the pcm? or when the break is applies no voltage
is sent? Right now i have 12v going to it all the time. thanks

Mike
----- Original Message -----
From: <Chipsbyal@aol.com>
To: <gmecm@diy-efi.org>
Sent: Saturday, May 13, 2000 8:51 PM
Subject: Re: A few lt1 ?'s


> You are correct, the wire from the brakes to the "PCM" is purple. There is
no
> wire from the brakes to the trans on a `96 B-body. The 12v power for the
TCC
> solenoids, there are two, comes from the emissions fuse and supplies power
to
> the entire trans along with the O2's, MAF, AIR pump relay, EGR and EVAP
> solenoids. The ground side as usual comes from the PCM.
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org