Re: Piggy backing 165 ECM chips

[DC Smith <morepoweral@tetranet.net>]

I'm not sure what chips you are using, but why not use a larger chip
and address the different sections individually. You can probably stack
several programs or so in one chip. Address it with a thumbwheel binary
switch. I have done this myself. Programming it was a pain though.

Rick Lindstedt wrote:
> 
> I have a thought and would like to know the consensus of "more"
> knowledgeable one out there on this..
> 
> I would like to have a chip for motor and a chip for nitrous on my car...
> can I use the ground pin on the chip to switch back and forth between the
> two? and if I can ..is it possible to do this on the fly as well, ie car
> running???
> 
> or is there a better method to this??
> 
> Thanks for any input or suggestions..
> 
> Rick
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

-- 
***********************************************************************
Dan Smith      84 Regal   11.841@115.09     GSCA# 1459
St.Charles, Missouri 
mailto:morepoweral@tetranet.net               
http://www.tetranet.net/users/morepoweral
***********************************************************************
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org