Re: Just soo obvious

[Pat Ford <pford@qnx.com>]

 If I have a flash (eeprom) that I don't trust I do all 0xff then and verify
followed by burning the address into the each memory location ( ie 0xC000 has 
0xC000 in it) followed by the compliment of the address ( 0x8000 gets 0x7fff)
that seems to weed out the bad chips fairly fast


Previously, you (nacelp) wrote:
{ If you're having problems with eprom burning and not sure about things in
{ general, here's a couple things that might help.
{ Make a .bin file of all:
{ zeros
{ all FF
{ the specific patterns,
{ burn tehm and then reread them into the .bin editor, or do a file compare.
{ I been having a problem, and was trying to narrow soen what was going on,
{ and a none lister mentioned this...
{ Just a diddy for us non EE's
{ Grumpy
{ 
{ ----------------------------------------------------------------------------
{ To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
{ in the body of a message (not the subject) to majordomo@lists.diy-efi.org
{ 

--
Pat Ford                           email: pford@qnx.com
QNX Software Systems, Ltd.           WWW: http://www.qnx.com
(613) 591-0931      (voice)         mail: 175 Terence Matthews          
(613) 591-3579      (fax)                 Kanata, Ontario, Canada K2M 1W8

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org